| Last Modified: 11-29-2007 | 1.6 G | |
| Service Category: Suspension | Section: Suspension Control System | |
| Model Year: 2008 | Model: Sequoia | Doc ID: RM000003F5Q000X |
| Title: SUSPENSION CONTROL: HEIGHT CONTROL SENSOR: INSPECTION (2008 Sequoia) | ||
INSPECTION
1. INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY
(a) Inspect the rear height control sensor sub-assembly LH.
(b) Connect 3 dry cell batteries of 1.5 V in series.
(c) Connect the positive (+) end of the batteries to terminal 3 (SHB) of the height control sensor and the negative (-) end of the batteries to terminal 1 (SHG). While slowly moving the sensor link up and down, measure the voltage between terminal 2 (SHRL) and terminal 1 (SHG).
(d) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
|
Tester Connection |
Sensor Condition |
Specified Condition |
|---|---|---|
|
2 (SHRL) - 1 (SHG) |
High (45°) |
4.4 to 4.6 V |
|
Normal (0°) |
2.3 to 2.6 V |
|
|
Low (-45°) |
0.4 to 0.6 V |
NOTICE:
Do not apply a voltage of more than 6 V.
|
(e) Inspect the rear height control sensor sub-assembly RH. |
(f) Connect 3 dry cell batteries of 1.5 V in series.
(g) Connect the positive (+) end of the batteries to terminal 3 (SHB) of the height control sensor and the negative (-) end of the batteries to terminal 1 (SHG). While slowly moving the sensor link up and down, measure the voltage between terminal 2 (SHRR) and terminal 1 (SHG).
(h) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
|
Tester Connection |
Sensor Condition |
Specified Condition |
|---|---|---|
|
2 (SHRR) - 1 (SHG) |
High (45°) |
4.4 to 4.6 V |
|
Normal (0°) |
2.3 to 2.6 V |
|
|
Low (-45°) |
0.4 to 0.6 V |
NOTICE:
Do not apply a voltage of more than 6 V.
|
|